Hayward Troubleshooting Guides

Find solutions for all your Hayward smart home device issues. Browse 5 troubleshooting guides across 1 device categories.

Visit Hayward Official Site

Browse by Device Type

Select a category to find Hayward troubleshooting guides

All Hayward Troubleshooting Guides (5)

Hayward AquaRite Salt Cell Not Generating Chlorine

Smart Pool & Spa • Hayward AquaRite Salt Chlorine Generator

Your Hayward AquaRite salt chlorine generator is running but your pool's free chlorine level keeps dropping to zero. The AquaRite control box (mounted on the wall near the pool equipment) shows the pump is running and the system is on, but chlorine production is not keeping up with demand. The salt cell (the clear cylindrical housing plumbed inline after the filter and heater) should produce visible bubbles inside the cell when actively generating chlorine through electrolysis. If you look through the clear cell housing and see no bubbles while the system shows it's generating, the cell plates may be scaled, the salt level may be too low, or the cell has reached end of life.

intermediate 30-60 minutes 24 views

Hayward OmniLogic App Not Controlling Pool Equipment

Smart Pool & Spa • Hayward OmniLogic

The Hayward OmniLogic app shows your pool system but tapping buttons to turn on the pump, heater, or lights does nothing. The OmniLogic touchscreen on the equipment pad may still work locally but remote commands from the app are ignored or delayed by minutes. This happens when the OmniHub (the WiFi module that bridges the OmniLogic controller to the internet) loses its cloud connection or when the RS-485 communication between the OmniHub and the OmniLogic main board has errors. The OmniHub is a small black box mounted inside the OmniLogic enclosure with a single Ethernet port and a status LED on the front.

intermediate 30-60 minutes 20 views

Hayward Pool Pump Not Priming or Losing Prime

Smart Pool & Spa • Hayward Pool Pump

The Hayward variable speed pump runs but the strainer basket does not fill with water, air bubbles are visible in the pump lid, or the pump loses prime after running for a few minutes. A pump that cannot pull water from the pool cannot circulate, filter, or chlorinate. Air leaks on the suction side are the most common cause — air enters the plumbing between the pool and the pump, breaking the vacuum the pump needs to pull water.

moderate 30 minutes 20 views

Hayward Pool Heater Not Igniting or Firing

Smart Pool & Spa • Hayward Pool Heater

The Hayward Universal H-Series gas pool heater does not ignite when the thermostat calls for heat. The heater may click (igniter firing) without lighting, show error codes on the display, or simply not respond at all. Common causes include insufficient water flow, gas supply issues, a dirty or failed igniter, or safety switches tripping.

moderate 30 minutes 14 views

Hayward TigerShark or AquaVac Robotic Cleaner Not Moving or Not Cleaning

Smart Pool & Spa • Hayward Robotic Pool Cleaner

The Hayward robot powers up but sits on the floor without moving, runs but leaves debris behind, or the power supply light flashes and the cleaner never starts. On these robots the fault is almost always at the power supply, the floating cable, the impeller, or the filter canister, and each has a quick check before you assume a dead motor.

medium 25 minutes 13 views